Table of Contents
Advertisement
The MedVue Model MV2 Medical Weight Analyzer allows several operational parameters to be
reviewed and changed as necessary without having to remove the end cap, pressing the
calibration switch, or breaking any seals to enter the Non-Protected Calibration Setup mode.
To Enter Setup Review
With the MV2 on and in the normal Gross weight mode:
1. Press and hold the CLEAR key for approximately 3 seconds.
2. The display will change to show SETUP REVIEW in small letters at the bottom of the
display.
3. Release the CLEAR key.
4. The display will change to show:
With SYSTEM displayed, press the ENTER key. The display will change to LANGUAGE. Note
that continued pressing of the ENTER key will advance you through the Setup Review
parameters. For information and instructions on how to change these parameters, refer to the
Calibration Setup (Non- Protected Setup Parameters) section of this manual.
Parameters in Setup Review will be processed in the following sequence:
SYSTEM
LANGUAGE
bACkLIGHT
KEYPAd bEEP
SLEEP MOdE
AUTO SHUT OFF
kEY dISAbLE
ENAbLE Id
bARCOdE
USE HEIGHT
HEIGHT UNITS
bOdY MASS IdX
HI RESOLUTION
NOTE: HEIGHT UNITS and bOdY MASS IdX will only be shown if USE HEIGHT is set to YES.
40
SETUP REVIEW
(Non-Protected Setup Parameters)
Select MV2 operation language
Set Backlight Intensity
Enable or Disable MV2 emitting a beep when a key is pressed
Disable or select number of minutes of inactivity for sleep mode
Disable or select number of minutes for automatic shutoff timer
Enable or Disable NET/GROSS, TARE and/or ID/HEIGHT keys
Enable or Disable transaction storage and ID number input feature
Enable or Disable barcode scanning of ID's
Enable or Disable Height Functions
Select Centimeters or Millimeters for height measuring units
Enable or Disable Body Mass Index (BMI) calculation feature
Enable High-Resolution Weight Mode feature
8555-0530-0M Rev E MedVue MV2 Owner's
Advertisement
Table of Contents
