Table of Contents
Advertisement
Battery Status Symbol
A battery status symbol will be displayed when
batteries are installed. The number of bars
indicates the level of charge remaining in the
batteries.
Low Battery Indicator
When the batteries are near the point they need to be recharged, the battery status symbol
will not show any bars. If the battery voltage drops too low for accurate weighing, the MV2
will automatically shut off and you will be unable to turn it back on.
Battery Charging
To recharge the Ni-Cad or NiMH batteries, the AC power adapter must be connected to an
AC power outlet and plugged into the indicator. It will take approximately 6 hours to fully
recharge the batteries in the indicator. While the batteries are charging the indicator can still
be operated. Note that charging the batteries for more than 6 hours will not damage them.
Battery Installation/Replacement
To install or remove the batteries, the following steps should be followed:
1. Make sure the AC power adapter is unplugged.
2. Remove the MV2 from the mounting bracket and turn it over so that the display is
facing away from you.
3. Locate the rectangular panel on the back of the MV2 and remove the thumb screw.
Refer to Figure No. 1.
4. Remove the panel (lift straight up and slide it out) exposing the battery holder.
5. If installing new batteries, proceed to step 6. If replacing the batteries, remove all 6
batteries from the battery holder and then proceed to step 6.
6. Install the new 6 "C" size batteries in the holder, noting the polarity markings located
in the battery holder. Refer to Figure No. 6.
7. After placing all 6 batteries in holder, replace panel on back of the MV2 (slide tab into
slot on rear panel) and install thumb screw.
8. Turn the MV2 over (display facing up) and press the ON/OFF key.
9. If display turns on, batteries have been installed correctly. If not, remove panel and
check for one or more improperly positioned batteries.
10. Return the MV2 to the mounting bracket.
11. The MV2 is now ready for operation.
+
I
INSTALLATION, CONT.
Figure No. 6
8555-0530-0M Rev E MedVue MV2 Owner's
4 Bars = 100%
3 Bars = 75%
2 Bars = 50%
1 Bar = 25%
No Bars = Low Battery
I
+
7
Advertisement
Table of Contents
