Table of Contents
Advertisement
The annunciators are turned on to indicate that the display is in the mode corresponding to the
annunciator label or that the status indicated by the label is active.
Weight
Display
Height or
Clock
Display
BMI
Display
Messages
Display
GROSS
The GROSS annunciator is turned on to show that the weight displayed is the gross weight.
Gross weight will be displayed when no tare weight value is stored.
TARE
The TARE annunciator is turned on to show that the MV2 is in a weight mode in which a
known tare (container) weight value is stored.
NET
The NET annunciator is turned on to show that the weight displayed is the net weight. Net
weight is determined by subtracting the stored tare weight from the gross weight. The tare
weight is usually the weight of the empty container. Note that the NET annunciator is only
active when a tare weight value is stored.
(STABLE)
The (
) annunciator is turned on when the weight display is stable. When off, it means
that the change in successive weight samples is greater than the motion limits selected
during setup and calibration of the MV2.
0
(ZERO)
The ( 0 ) annunciator is turned on to indicate that the weight is within +/- 1/4 division of
the center of zero.
(LOCK)
The ( ) annunciator is turned on to show that the MV2 is locked onto the displayed
weight. In operation after obtaining a stable weight value, pressing the LOCK/RELEASE
key (or resetting the Auto Lock) will cause the MV2 to lock onto the weight and turn on
the annunciator. Pressing the LOCK/RELEASE key a second time (or dropping below
the Auto Lock reset value) will unlock the display and turn off the annunciator. NOTE:
The lock feature (Hold Mode) must be enabled during Calibration Setup.
ANNUNCIATORS
Figure No. 8
8555-0530-0M Rev E MedVue MV2 Owner's
Battery
Status
Displayed
when optional
hardware is
installed.
11
Advertisement
Table of Contents
