Table of Contents
Advertisement
The 750EU indicator allows several operational parameters to be reviewed and changed as
necessary without having to enter the setup mode.
To Enter Setup Review:
1. If indicator is on, press ON / OFF key.
2. Display will show oFF and indicator will turn off.
3. Press and hold BMI / ENTER key and then press ON / OFF key.
4. Indicator will perform a lamp test (turn on all segments of display), display model
number and software revision and then display tra= prompt.
5. With display showing tra=, release BMI / ENTER key.
6. Refer to instructions listed in Setup and Calibration section for information on how to
change parameters.
Parameters in Setup Review will be processed in the following sequence:
tra
Select the number of scale divisions automatically zeroed on power up
PUO
Enable or Disable automatic reset of weight display to zero on power up
niCAd
Select to enable battery charging and type of charging
SLeeP
Disable or select number of minutes of inactivity at zero for sleep mode
ASH
Disable or select number of minutes for automatic shutoff timer
ERROR AND STATUS DISPLAYS
Display
General error, invalid keypad entry was attempted.
-Err-
-ouF-
Attempting to display a negative number greater than –99,999 or a
positive number greater than 999,999
-trL-
Indicates an attempt to zero a weight outside scale zero range.
(See Four Percent Zero Tracking Range Limit).
•
-UnS-
Motion is present when indicator is attempting to perform one of the
following operations: Power Up Zero or Zero Weight Display
CALib
Indicates calibration is necessary.
AdErr
ErrAL
ErrAH
OCAP
Scale weight exceeds scale capacity
Displayed to indicate indicator is turning off.
OFF
SETUP REVIEW
Press ON / OFF key to power down scale. Remove weight from
scale and then press ON / OFF key to power up scale.
Consult your scale service representative.
8555-M260-O1 Rev J • 750EU Owner's
Meaning
17
Advertisement
Table of Contents
