Table of Contents
Advertisement
CHAPTER 5
In order to let the system board to work efficiently, a series of drivers have to install according
to the operating system used. The drivers may be delivered via CD-ROM or floppy diskettes.
The device driver installation procedures from CD-ROM and floppy diskettes are similar. The
only difference is the path of the driver location. Please refer to the following section for the
installation procedures for floppy diskettes. For CD-ROM installation, please refer to the
README.TXT file on the Root Directory of the CD-ROM.
5.1
WIN95 BUS MASTER IDE DRIVER
INSTALLATION
The Win95 Bus Master IDE Driver let you enable or disable the Ultra DMA or PIO
IDE Devices under Windows 95.
a)
Under Windows 95, insert the CD into CD-ROM (say d:)
b)
Click Start on the taskbar in Windows 95
c)
Click Run on the menu bar in Windows 95
d)
Type d:\VIAAGP\Drivers\IDE MASTER\setup
e)
Follow the on screen instructions to complete the installation
f)
After the installation is completed, Windows 95 should be restarted to let the
drivers take function
5.2
VIA POWER MANAGEMENT CONTROLLER
SETUP PROGRAM FOR WINDOWS 95
This program is used to patch the VIA Power Management Controller for the ACPI
function of Windows 95.
a)
Under Windows 95, insert the CD into the CD-ROM (say d:)
b)
Click Start on the taskbar in Windows 95
c)
Click Run on the menu bar in Windows 95
d)
Type d:\VIAAGP\Drivers\ACPI\setup
e)
Follow the on screen instructions to complete the installation
f)
After the installation is completed, Windows 95 should be restarted to let the
drivers take function
SOFTWARE
INSTALLATION
51
Advertisement
Table of Contents
