Table of Contents
Advertisement
Award BIOS Setup Guide
IDE Primary Master PIO/IDE Primary Slave PIO/IDE Secondary Master PIO/IDE
Secondary Slave PIO: Available selection are "Auto", "Mode 0", "Mode 1", "Mode 2", "Mode
3" and "Mode 4". To choose "Auto", the system BIOS will scan the IDE device and decide
which mode of the device is. Otherwise the user should key in the mode of the device to the
corresponding field.
Some harddisks cannot work properly with its corresponding timing, please set a slower
timing.
IDE Primary Master UDMA/IDE Primary Slave UDMA/IDE Secondary Master
UDMA/IDE Secondary Slave UDMA: Available selection are "Auto" or "Disabled". To
choose "Auto", the system BIOS will scan the IDE device and decide Ultra DMA supported or
not.
Init Display First: To select priority of initialization the PCI display card or the AGP display
card.
POWER ON Function: To support PS/2 mouser power on (hit the left key or the right key of the
mouse two times) and keyboard password power on.
KBC input clock: To select the keyboard controller frequency 6, 8, 12, 16MHz.
Onboard FDD Controller: Choose Enabled or Disabled. Enabled allows onboard Floppy Drive
Controller to be functioned, otherwise the users should use other sources.
Onboard Serial Port 1: Choose Auto, Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4 and
2E8/IRQ3. While choosing proper I/O Address/IRQ, be sure not to cause Address conflict with
other I/O devices. The default setting is 3F8/IRQ4.
Onboard Serial Port 2: Choose Auto, Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4 and
2E8/IRQ3. While choosing proper I/O Address/IRQ, be sure not to cause Address conflict with
other I/O device. The default setting is 2F8/IRQ3.
UART Mode Select: Available selection are "Normal", "IrDA" and "ASKIR".
Onboard Parallel Port: Choose None or with four different I/O Address and corresponding
IRQx. While choosing proper I/O Address, be sure not to cause Address conflict with other I/O
devices.
Parallel Port Mode: Choose SPP, EPP, ECP, ECP+EPP Mode. Make proper selection with the
attached printer port device.
ECP Mode Use DMA: Choose "1" or "3" to select the DMA channel used for the ECP device.
This item is shown if the Onboard Parallel Mode is chosen as "ECP" or "ECP/EPP" option.
43
Advertisement
Table of Contents
