Adjusting The Steering Head Bearing Play - KTM 85 SX 2022 Owner's Manual

11.12

Adjusting the steering head bearing play

Main work
–
Move the handlebar to the straight-ahead position. Move the
fork legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
» If there is detectable play:
–
Adjust the steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the
H01167-01
entire steering range. There should be no detectable detent
positions.
» If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and replace if
required.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Pull fuel tank breather
–
Loosen screws
–
Loosen screw
–
Loosen and retighten nut
Guideline
Nut, steering stem
–
Using a plastic hammer, tap lightly on the upper triple clamp
S03421-10
to avoid stresses.
–
Tighten screw
Guideline
Steering stem clamp
screw
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Position the fuel tank breather
Finishing work
–
Check the steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
SERVICE WORK ON THE CHASSIS 11
1
out of the steering stem.
2
.
3
.
4
.
M20x1.5 10 Nm (7.4 lbf ft)
3
.
M8 20 Nm (14.8 lbf ft)
2
.
M8 17 Nm (12.5 lbf ft)
1
in the steering stem.
p. 52)
( p. 53)
( p. 53)
p. 45)
p. 45)
p. 45)
53