Handlebar Position; Adjusting The Handlebar Position - KTM 85 SX 2022 Owner's Manual

10.16

Handlebar position

10.17

Adjusting the handlebar position

Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
Info
Turn clockwise to increase the damping; turn counter-
clockwise to reduce damping when the shock absorber
rebounds.
On the upper triple clamp, there are 2 holes at a distance of
each other.
Hole distance A
The holes on the handlebar supports are placed at a distance
B
of from the center.
Hole distance B
The handlebar supports can be mounted in four different posi-
tions. This allows the handlebar to be mounted in the most com-
C00248-10
fortable position for the rider.
–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount
C00249-10
and tighten screws
Guideline
Screw, handle-
bar support
–
Position handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position handlebar clamps. Mount screws
evenly.
TUNING THE CHASSIS 10
15 mm (0.59 in)
3.5 mm (0.138 in)
1
. Take off the handlebar clamps. Remove
2
. Take off the handlebar support.
2
.
M10 40 Nm (29.5 lbf ft)
1
A
to
Loctite 243™
®
and tighten
43