Installing The Fork Legs - KTM 85 SX 2022 Owner's Manual

11.6

Installing the fork legs

–
Loosen screws
–
Loosen screws
V00873-10
–
Position the fork legs.
Air bleeder screw
the front.
A
Valve
Info
The second milled groove (from the top) must be flush
with the upper edge of the upper triple clamp.
The air suspension is located in the left fork leg. The
H02312-11
pressure and rebound damping is located in the right
fork leg.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
V00873-11
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease (
–
Insert the spacers.
H00935-15
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position the front wheel.
–
Insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
S04277-10
SERVICE WORK ON THE CHASSIS 11
3
. Remove the left fork leg.
4
. Remove the right fork leg.
1
of the right fork leg is positioned to
of the left fork leg faces the front.
2
.
M8 17 Nm (12.5 lbf ft)
3
.
M8 15 Nm (11.1 lbf ft)
4
and contact surfaces
p. 125)
p. 125)
5
.
M20x1.5 35 Nm (25.8 lbf ft)
B
47