Installing The Fork Protector; Removing Fork Legs; Installing The Fork Legs - KTM 450 RALLY FACTORY REPLICA 2023 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.6
12.7
12.8
58

Installing the fork protector

A00456-11

Removing fork legs

A00467-10
A00468-10

Installing the fork legs

A00451-11
–
Position fork protector on the right fork leg. Mount and tighten
1
screws .
Guideline
Remaining screws,
chassis
–
Position brake line, wiring harness, and clamp. Mount and
2
tighten screws .
–
Position fork protector on left fork leg. Mount and tighten
3
screws .
Guideline
Remaining screws,
chassis
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove front wheel. (
Main work
–
1
Remove screws .
–
Allow the brake caliper and brake line to hang loosely to the
side.
–
2
Loosen screws . Take out the right fork leg.
–
3
Loosen screws . Take out the left fork leg.
Main work
–
Position fork legs.
1
Bleeder screws are positioned toward the front.
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 56)
p. 101)