Cls - Clear Status; Ese <Nrf> - Event Enable - ITech IT6400 Series Programming Manual

*STB?
*TRG
*TST?
*WAI
*CLS — Clear Status
This command clears the bits of the following registers:




Command syntax
*CLS
Arguments
None
*ESE <NRf> — Event Enable
This command programs the Standard Event Status Enable register bits. The
programming determines which events of the Standard Event Status Event
register (see *ESR?) are allowed to set the ESB (Event Summary Bit) of the
Status Byte register. A "1" in the bit position enables the corresponding event.
All of the enabled events of the Standard Event Status Event Register are
logically ORed to cause the Event Summary Bit (ESB) of the Status Byte
Register to be set.
Command syntax
*ESE <NRf>
Arguments
0 to 255
Default Value
see *PSC
query
Read status byte query
Trigger Command
Self-test query
Wait to
command
Standard Event Register
Operation Event Register
Questionable Event Register
Error Queue
Copyright © Itech Electronic Co., Ltd.
Register.
Reads the Status Byte Register.
Send a trigger to Power supply.
Perform selftest, then return result.
continue Wait until all previous commands are
executed.
IEEE-488 Commands
12