Chapter12 Ieee488 Commands; Cls - Clear Status; Ese <Nrf> - Event Enable - ITech IT8500+ Series Programming Manual

This chapter describes IEEE-488 common commands provided by the IT8500+
series electronic load.

*CLS - Clear Status

This command clears the registers:
_ Standard Event Register
_ Operation Event Register
_ Questionable Event Register
_ Error Queue
Command syntax
*CLS
Parameters
None
<NRf> - Event Enable
*ESE
This command programs the Standard Event Status Enable register bits. The
programming determines which events of the Standard Event Status Event
register (see *ESR?) are allowed to set the ESB (Event Summary Bit)
of the Status Byte register. A "1" in the bit position enables the corresponding
event. All of the enabled events of the Standard Event Status Event Register
are logically ORed to cause the Event Summary Bit (ESB) of the Status Byte
Register to be set. See chapter "Programming the Status Registers" for
descriptions of the Standard Event Status registers.
The query reads the Standard Event Status Enable register.
Command Syntax
*ESE <NRf>
Parameters
0 to 255
Powe-on Value
see *PSC
Examples
*ESE 129
Query Syntax
*ESE?

Chapter12 IEEE488 Commands

Copyright © ITECH Electronic Co., Ltd.
IEEE488 Commands
65