Chapter7 Common Commands; Cls; Ese - ITech IT8600 Series Manual

*CLS

This command is used to clear following registers:



Command syntax
*CLS
Parameter
None

*ESE

This command is used to edit the value of standard event enable register. It
defines the specified bits from standard event register that will cause the value
of ESB bit in status byte register to be 1.
Command syntax
*ESE <NR1>
Parameter
0～255
Power-On Value
Refer to *PSC command
Example
*ESE 128
Query Syntax
*ESE?
Returned value
<NR1>
Relevant Command
*ESR? *PSC *STB?

Chapter7 Common Commands

Standard Event Register
Questionable Event Register
Status Byte Register
Copyright © Itech Electronic Co., Ltd.
Common Commands
59