Table of Contents
Advertisement
Installation
4.8.1
Alternative installation
Transport stops can be installed on the inside or outside of the slider profile. This is done by swapping posi-
tion on the right and left sides respectively.
1. Run the lift to transport position.
2. Unscrew the end caps from the slide profiles.
3. On each slide profile, unscrew the nut that tensions the chain and the two nuts that hold the bracket.
4. Swap position of the left and right-hand brackets. Screw each bracket into place with the two nuts.
Tightening torque: 80 Nm.
5. Screw and tighten the chain by tightening the nut.
Tightening torque: 50 Nm.
www.zepro.com
Alternative 1
Picture 37. Alternative transport stop installation
Alternative 2
ZT MK2
27
Advertisement
Table of Contents
