9.3 What to Do If an Error Occurs
9.3 What to Do If an Error Occurs
9.3.1 ERROR LED Flashes on the Control Unit
■
Condition
A self-diagnostic error has occurred.
■
Solution
Check the condition according to the following procedure.
1.
On the GM Programmer, select Online>Status and check the error content (error code).
2.
Switch to the STOP mode.
3.
On the Status screen of the GM Programmer, check the error information.
In case of an operation continue error, the error can be resolved by RTEX Reset / Error
Clear.
4.
Cancel the situation in accordance with the error code.
● For the error codes, refer to the , GM1 Controller RTEX User's Manual (Operation) or GM1
Controller EtherCAT User's Manual (Operation).
9.3.2 ALARM LED Lights on the Control Unit
9-4
WUME-GM1H-02