Device Reset By Gm1 Controller Operation - Panasonic GM1 Series Reference Manual

8.1 Device Reset by GM1 Controller Operation

8.1 Device Reset by GM1 Controller Operation
Controller information on the GM Programmer can be deleted (initialized) from the GM1
Controller.
1.
Confirm that the power supply is turned OFF, set the mode selector switch to "STOP", and
set SW2 (reset bit) of the DIP switch to "ON".
2.
When the power supply is turned ON, the [RUN] [STOP] [ERROR] LEDs are lit and a
device reset is executed.
3.
When the [RUN] [STOP] [ERROR] LEDs go out, the device reset is completed.
When the device reset is completed, turn "OFF" the power supply, and set the reset bit to
"OFF".
Device reset can be executed from the GM1 Controller as well as from GM Programmer. For
details on the device reset, refer to the GM1 Controller RTEX User's Manual (Operation) or
GM1 Controller EtherCAT User's Manual (Operation).
8-2 WUME-GM1H-02