Table of Contents
Advertisement
2.
Put the axle (fig. 3-1/3) onto the mounting tool.
Required material, see table on page 9.
3. Put the non disc side of the hub shell onto the tool
and the axle.
4. Slightly grease the bearing (fig. 3-1/2) and put it
onto the disc side with the colored side facing out-
wards.
5. Put the dismounting tool onto the axle.
6. Put the mounting tool onto the bearing.
The dismounting tool centers the mounting tool
on the axle.
Required material. see table on page 9.
7. Tap the bearing into the hub shell with slight ham-
mer strokes.
The lower mounting tool must lay on an even
surface.
8. Remove the tool from the hub.
CLASSIC Wheels - Technical Manual
12
Advertisement
Table of Contents
