Table 22: Configuring The Identity - WAGO -TO-PASS 761 Manual

Telecontrol module compact, 2 ai telecontrol module for fault detection/indication, monitoring and remote control
Hide thumbs Also See for WAGO-TO-PASS 761:
Table of Contents

Advertisement

WAGO-TO-PASS® 761
761-111 Telecontrol Module Compact, 2 AI

Table 22: Configuring the identity

General
Function selection You can redifine the firmware version in this selection field,
Name
Phone number
PIN
Roaming
Prepaid
Alarm counter
Manual
Version 2.0.0
that is to say the available scope of functions (e.g., to ensure
compatibility with devices already in use).
When you define an older firmware version a check is first
conducted to determine whether the settings made for this
version can be used.
The module name of the TO-PASS
displayed in this field. The module name is assigned when a
new module is set up and can only be changed later by
overwriting it with a new identity (not via a modem
connection).
In this field enter the phone number of the SIM card used in
the module.
To use the PIN number of the installed SIM card, click the
[Use PIN] button and enter the PIN number in the field
provided.
Roaming is always activated in TO-PASS
modules.
To select a favorite carrier, click the [Allow] button and enter
the 5-digit carrier ID in the field provided. The telecontrol
mode will then always attempt to use this favorite carrier
while roaming.
Click the [Poll] button to transmit information with the data
telegram to a prepaid card that you use. In the input field
enter the 5-digit polling code, e.g., "*100#" to determine your
remaining balance. Entering of a polling code is possible
starting with Firmware Version FW 2.33.
Enter the maximum value in this field to limit the number of
alarms transmitted by the TO-PASS
hour.
If, in the event of a failure (e.g., loose connection), the
maximum number is exceeded, alarms will no longer be sent.
The alarm counter can be reset by an SMS being sent to the
®
TO-PASS
telecontrol module with the text "RESET", or by
switching the TO-PASS
again.
Enter a value of "0" to deactivate limiting.
Parameterizing
®
telecontrol module is
®
telecontrol
®
telecontrol module each
®
telecontrol module off and then on
49

Advertisement

Table of Contents
loading

This manual is also suitable for:

761-111

Table of Contents