Removal Of Mowing Deck Rider 1030 And Rider 1200; Removal Of Mowing Deck Rider 970 - Husqvarna Rider 850 Workshop Manual

Removal of mowing deck Rider 1030
and Rider 1200
1
4
1
Remove the front cover. Set the cutting height to
the lowest position.
2
Relieve the connecting rod (1). A breaking bar may
be used, when the hair-needle spring is removed,
to carefully bend the connecting rod out of its
holder.
3
Release the tensioning wheel (2) by disconnecting
the spring (3).
4
Bend the locking plate (5) forwards and press down
the deck's front edge so that it is released from the
deck frame (4).
5
Press the deck backwards and twist off the drive
belt. Then pull the deck forwards so that the back
end is released from the deck frame.
6
Installing the mowing deck takes place in the
reverse order to removal.
!
WARNING!
When working on the mowing deck, wear protective glasses and
gloves.
2
3
5

Removal of mowing deck Rider 970

2
5
1
Remove the front cover.
2
Set the cutting height to the highest position. Push
the stop (1) in against the crossbar and then set
the cutting height to the lowest position. The
mowing deck is now locked vertically.
3
Relieve the tensioning roller (2) by disconnecting
the spring (3).
4
Bend the locking plate (5) forwards and press down
the deck's front edge so that it is released from the
deck frame (4).
5
Press the deck backwards and twist off the drive
belt.
6
Remove the hair-needle spring and release the
crossbar (6) from the height adjustment.
7
The deck can now be pulled forward until it
releases from the rear suspension.
8
Installing the mowing deck takes place in the
reverse order.
Reparation instructions
3
4
1
6
English –
37