Parking Brake; V-Belts; Deck Belt Removal - Husqvarna EZ22 Operator's Manual

Parking Brake

Visually check that no damage is found on the lever,
cables, or switch belonging to the parking brake.
Perform a standstill test and check that there is
suffi cient braking action.
To adjust the parking brake, contact the Husqvarna
service workshop.
IMPORTANT INFORMATION
The machine must be absolutely standing still
when applying the parking brake.

V-belts

Check every 100 hours of operation. Check for severe
cracking and large nicks.
NOTE: The belt will show some small cracks in normal
operation.
The belts are not adjustable. Replace belts if they
begin to slip from wear.

Deck Belt Removal

1. Park on a level surface. Apply parking brake.
2. Lower the deck into the lowest cutting position.
3. Remove bolts from belt shields and remove
shields.
4. Remove any dirt or grass that may have
accumulated around the cutter housings and entire
deck surface.
5. Relieve tension on the belt by moving the idler
arm.
6. Carefully slip belt up over the top of the cutter
housing pulleys and remove belt. Rolling belt over
the pulleys may damage the belt.
38
-Husqvarna
MAINTENANCE
Parking brake
Belt Shields
Removing deck belt
WARNING!
Faulty adjustment will result in
reduced braking ability and can
cause an accident.
8058-020c
Idler arm