3.1 Versions
With insulating section/bellows seal
The modular design allows an insulating sec-
tion or bellows seal to be fitted to the stan-
dard valve version.
Micro-flow valve version
In the micro-flow valve version, a micro-trim
element is installed in the valve body instead
of the usual seat/plug assembly (Fig. 3-3).
4a
4b
4c
4d
4a
Seat body
4b
Spring
4c
Seat
4d
Nut
5a
Plug stem
5b
Plug
Fig. 3-3: Micro-trim element
EB 8015 EN
Design and principle of operation
Actuators
In these instructions, the preferable combina-
tion with a SAMSON Type 3271 or
Type 3277 Pneumatic Actuator is described.
The pneumatic actuator (with or without
handwheel) can be replaced by another
pneumatic actuator in a different size, but
with the same travel.
Î Observe the maximum permissible actu-
ator force.
Note
If the travel range of the actuator is larger
than the travel range of the valve, the spring
5a
assembly in the actuator must be preloaded
so that the travel ranges match. See associ-
ated actuator documentation.
5b
The basic pneumatic actuator can be re-
placed by a pneumatic actuator with addi-
tional handwheel or by an electric actuator
(see Information Sheet u T 8300).
3-3