Function List - Mitsubishi Electric MR-J5-G User Manual

Function list

Communication-related function list (Application)
Category Subcategory Functions
Network Open network CC-Link IE Field
Network Basic protocol
CC-Link IE Field
Network Basic
communication settings
Common SLMP
protocol
Profile CSP+
Application Cyclic Hold/Clear of output at
function transmission CPU STOP and CPU
stop error
Setting change Remote reset
IP address setting
Description
This function supports CC-Link IE Field Network Basic.
Network configuration settings are performed by using GX Works2,
GX Works3, and MR Configurator2.
This function supports SLMP (SeamLess Message Protocol).
Parameter settings and monitoring are available.
File for describing the necessary information for startup, operation,
and maintenance of CC-Link family connected products.
When the CPU module of the cyclic master is at STOP, when the stop
error occurs, Hold/Clear is automatically set on the refresh device
output. The servo amplifier stops regardless of the setting of Hold/
Clear of the cyclic master.
This is a function to reset a servo amplifier via the network. Servo
parameters to be enabled at power cycle are reflected by resetting
the servo amplifier.
IP addresses are delivered from the controller to servo amplifiers via
CC-Link IE Field Network Basic.
Detailed explanation
Page 65 Cyclic
transmission
Page 60 Startup
Page 81 SLMP
Page 61 Profile
(CSP+ file) settings
Page 64 Hold/Clear
of output at CPU STOP
and at CPU stop error
Page 64 Remote
reset
Page 63 IP address
setting function
2 CC-Link IE Field Network Basic
2.1 Functions and configuration
2
55