Oracle X6-2 Installation Manual page 43

Exadata storage server extreme flash

Hide thumbs Also See for X6-2:

Table of Contents

The CMA has three cable covers, two with two hinges (one of which is shown the

Note -

following figure), and one with a single hinge. All three cable covers are shown in the

illustration in

Step

Apply upward pressure to the outside edge of each hinge connector until the

hinge connector comes off the hinge [frame 3].

Repeat

Step 3a

and

One at a time, position each round cable cover horizontally over the hinges,

and align the hinge connectors with the hinges.

Using your thumb, apply downward pressure on each hinge connector to

snap the hinge connector into place.

Step 3b

to remove all three cable covers.

Install the Cable Management Arm

Installing the Storage Server Into a Rack

Table of Contents