Oracle X6-2 Installation Manual page 44

Install the Cable Management Arm
f. Swing the cable covers down and press down on the cable cover handle to
lock them into the closed position.
Ensure that the six Velcro straps are threaded into the CMA.
4.
Note -
opening in the top of the slide bar as shown in the illustration in
straps from interfering with the expansion and contraction of the slide bar when the storage
server is extended out of the rack and returned into the rack.
5. Extend the storage server approximately 13 cm (5 inches) out of the front of the
rack.
Take the CMA to the back of the equipment rack, and ensure that you have
6.
adequate room to work at the back of the storage server.
Note -
the equipment rack.
Note -
under its own weight until it is secured at all four attachment points.
7. To install the CMA's connector A into the left slide-rail:
a. Insert the CMA's connector A into the front slot on the left slide-rail until it
locks into place with an audible click [frames 1 and 2].
The connector A tab (callout 1) goes into the slide-rail's front slot (callout 2).
44 Oracle Exadata Storage Server X6-2 Extreme Flash Installation Guide • July 2018
Ensure that the two Velcro straps located on the front slide bar are threaded through the
References to "left" or "right" in this procedure assume that you are facing the back of
Throughout this installation procedure, support the CMA and do not allow it to hang
Step 1. This prevents the Velcro