Step 5: Assembling The Handlebars - Maxxus 4.2 R Installation & Operating Manual

Assembly

Step 5: Assembling the Handlebars

Pass the hand pulse sensor cable and the cockpit cable coming
out of the top of the handlebar (D), from below and up through
the opening in the handlebars (E). Now pull the cable end just far
enough out so that you can connect them to the cockpit. Now fix
the handlebar (E) to the handlebar shaft (D) using two hexagon
socket screws M8x25 (12)
CAUTION:
When attaching the handlebars (E), be very careful not to crush
or damage the cables.
Step 6: Assembling the Cockpit
Loosen and remove the four pan head screws (B57) already
preassembled on the back of the cockpit (K). Connect the cables
protruding from the cockpit (K) with the cables protruding from
the handlebars. Carefully check the cable connections. Carefully
push the excess cables back into the handlebar shaft (D). Now
secure the cockpit (K) to the handlebar shaft (D) using the four
pan head screws (B57) you previously loosened.
CAUTION:
When attaching the cockpit (K) make sure that you do not crush
or damage the cables.
Step 7: Assembling the Bottle Holder
Loosen and remove the two Allen screws (B16) already preas-
sembled on the handlebar shaft (D) and use them to attach the
bottle holder (M) to the handlebar shaft (D).
E
D
B16
8
12
D
D
D
K
B57