Recommended Accessories - Maxxus 4.2 R Installation & Operating Manual

My training device makes noises during training – is this normal?
Your MAXXUS® training device is equipped with high-quality ball-bearings and a grooved belt. In addition, it also has a high-quality
magnetic braking system which is completely wear and friction free. All these extremely high-quality components ensure that all func-
tional noises are very much reduced. Your MAXXUS® training device is one of the quietest products available in the fitness market.
However, it is possible and normal that slight mechanical noises are noticeable during training. These mechanical noises, which either
continually or sometimes occur at certain intervals are created by the very high rotational speed of the flywheel. Also, moving parts may
generate sounds during training, which are amplified by the hollow metal tubes of the frame. It is also quite normal for running noise to
get louder during your workout. This can be explained by an increase in training speed and by the device components heating up and
expanding during training.
The cockpit does not show anything in the display when I turn it on.
Check if the power cable is both attached correctly to the device and properly plugged into the socket, and/or if it is damaged. Check if
the control cable has been pinched or jammed during assembly and / or if the connector has come loose.
The pulse rate value is not shown or is indicated incorrectly
Please refer to the „Pulse & Heart Rate Measurement" sections in this manual.
The hand pulse rate sensors are not functioning
Check if the hand sensor cables have been pinched or jammed during assembly.
The speed and distance values are indicated to be„0"during training.
Check if the control cable has been pinched or jammed during assembly and/or if the connections have come loose.
My training device makes creaking noises during training.
Check if the training device is standing straight and flat on the ground. If not, re-adjust the foot stands. Check if the screws at the articu-
lated joint between the pendulum tubes and the pedal arms are tightened securely.
My feet fall asleep during training.
The reason for this is often that training shoes are done up too tightly. Your feet will expand when you are under exertion and so you
should do up your shoes more loosely. You can also get advice regarding this from sports shops or specialist running shoe shops.
These accessories are best suited for use with your training device. All products are
available from our online shop at www.maxxus.com.
POLAR® Transmitter Chest Belt T34 (uncoded)
Chest strap for determining the heart rate with optimized transmission ranges. Required
accessory for the application of pulse-controlled programs and for continuous determina-
tion of the current heart rate.
MAXXUS® Floor Protection Mats
Due to its extreme density and material thickness of 0,5cm, these mats provide perfect
protection for floors and floor coverings against damaging, scratches and soiling through
body sweat. Noise caused by running and movement is significantly reduced.
Available in the following sizes:
− 160 x 90 cm
− 210 x 100 cm
− 240 x 100 cm
MAXXUS® Degreaser Spray - Optimum cleaner for cleaning off dirt and maintaining the
guide pipes and roller surfaces.
MAXXUS® Lubricating Spray – Optimum lubrication for guide pipes.
MAXXUS® Anti-Static Spray – Effective against the static charges created in frames,
clothing and training computers. Devices which are located on carpets or synthetic floors
will become statically charged. MAXXUS ® Anti-Static Spray will deter this.
Synthetic surfaces treated with MAXXUS® Anti-Static Spray do not attract dust as quick-
ly and will remain clean for longer.
MAXXUS® Special Foam Cleaner – Use for regular cleaning of your training device.
Plastic covers and metal frames can be easily cleaned and perfectly maintained with
MAXXUS ® Special Foam Cleaner. It is also suitable for cleaning pulse belts and other
training accessories.
27

Recommended Accessories

FAQ
ENG