Mains Connection; Connecting The Device - Maxxus 4.2 R Installation & Operating Manual

Mains Cable
Insert the connector of the power cable supplied into the socket
located on the rear front of the main housing. Then connect the
mains cable to a power socket.
NOTE:
The USB connection on the cockpit of this training device is not
for the connection of the mains adapter!! This USB connector is
only for the connection of a USB charging cable (not included in
delivery) for smartphones, Tablet PC's, Ebooks etc.
CAUTION:
This device is only to be connected to an earthed socket installed
by a qualified electrician. Do not use a socket strip. If an exten-
sion cable is required, then it must comply with DIN standards,
VDE regulations and guidelines, technical rules issued by other
European Union member states or other states which are party to
the Agreement in the European Economic Area.

Connecting the Device

CAUTION:
Before connecting the mains adapter to the device, always check
that it is the mains adapter supplied with the device. Using a dif-
ferent mains adapter may damage the electronic components of
the device, for which the manufacturer assumes no liability.
Always connect the power cable to the exerciser before connect-
ing it to a power outlet. If you want to disconnect your exerciser
from the power supply, always disconnect the power cable from
the mains first.
Switching on the Device
First connect the power cable to the exerciser and then connect the mains cable to the power socket, the cock-
pit turns on automatically. If the training device is already connected to the mains, but the cockpit is in stand-by
mode, activate the cockpit by pressing any key or by moving the pedals.
Turning off the device
When inactive for more than 4 minutes, the cockpit automatically switches to stand-by mode. Once you have
finished your workout you should always disconnect the training device from the mains. Always unplug the
mains cable from the wall socket first and then remove the power cable.
13

Mains Connection

ENG