Checking The Headlight Setting - KTM 125 EXC 2015 Setup Instructions

3 WORK
3.12 Refitting the headlight mask with the headlight
3.13

Checking the headlight setting

3.14 Adjusting the headlight range
Main work
–
Connect the electric plug connector
602763-10
–
Position the headlight mask and fix it with the rubber band
Info
Ensure that the holding lugs engage in the fender.
–
Position the brake line and wiring harness. Put on the clamp and mount and
tighten screw
602762-11
Finishing work
–
Check the headlight setting. (
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
Guideline
Distance
–
Position the vehicle vertically a distance
Guideline
Distance
400726-10
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by swiveling the headlight.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
602764-10
The headlight range may need to be corrected if luggage is carried on the
vehicle.


.
p. 14)

under the first mark.


p. 14)

.
.

.
5 cm (2 in)

away from the wall.
5 m (16 ft)
p. 14)
14