KTM 125 EXC 2015 Setup Instructions page 12

3 WORK
3.6 Installing the fuel tank
Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
3.7 Installing the shock absorber
Main work
–
Check the routing of the throttle cable.
–
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
–
Make sure that no cables are trapped or damaged.
602721-01
–
Mount the fuel tank vent hose.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
(EXC EU/AU, 300 EXC BR)
–
Position the horn with the horn bracket.
602720-10
–
Mount and tighten screws
Guideline
Remaining screws, chassis
–
Connect the fuel hose.
602742-11
Finishing work
–
Mount the seat. (
Main work
(All 125/200 models)
–
Push splash protector
and tighten screw
Guideline
Screw, top shock
absorber
–
Mount and tighten screw
B02157-11
Guideline
Screw, bottom shock
absorber

with the rubber bushing.
M6
 with the collar sleeve.
M6
p. 8)

to the side and position the shock absorber. Mount

.
M12

.
M12
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
80 Nm Loctite ® 2701™
(59 lbf ft)
80 Nm Loctite ® 2701™
(59 lbf ft)
10