2
SETUP
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
B02185-01
–
Position the controls on the left half of the handlebar.
Info
The figure shows how to route the clutch line and wiring harness.
B02186-01
(All EXC models)
–
Remove the fuel tank. (
–
Disconnect the plug-in connector from the main wiring harness.
–
Connect the plug-in connector of the turn signal wiring harness with the plug-in
connector of the main wiring harness.
–
Position the turn signal wiring harness against the main wiring harness and
secure with cable binders.
–
Install the fuel tank. (
–
Position the turn signal indicator lamp in the speedometer holder.
B01750-01
–
Insert the black and violet cables of bulb included in the separate enclosure
into the socket and position it in the turn signal indicator lamp.
–
Secure the turn signal relay
–
Position the turn signal on each side and mount and tighten nuts
–
Connect the plug-in connector
marked green on the wiring harness.
–
Connect the plug-in connector
marked red on the wiring harness.
B02188-10
(EXC EU/AU, 300 EXC BR)
–
Mount the turn signal switch and connect the plug-in connector with the wiring
harness.
401382-01
p. 9)
p. 10)
with a cable tie and plug in the connector.
of the right turn signal with the connector
of the left turn signal with the connector
5
.