Internal Web Pages; Accessing The Internal Web Page - Extron electronics FOX3 Matrix Series User Manual

Internal Web Pages

This section introduces using the Internal Web Page to operate the FOX3 matrix switcher,
including:
•
•
The matrix can be configured through its LAN port, connected via a LAN or WAN, using a
web browser such as the Microsoft
installed HTML pages, which are always available and cannot be erased or overwritten.
NOTE: If the Ethernet connection to the matrix switcher is unstable, try turning off

Accessing the Internal Web Page

Access the FOX3 Matrix Switcher internal web page as follows:
1.
2.
3.
4.
5.
Accessing the Internal Web Page
Web Page Panels
the proxy server in the web browser. In Microsoft Internet Explorer, click Tools >
Internet Options > Connections > LAN Settings, uncheck the Use a proxy
server... box, and then click OK.
Connect the FOX3 device to a LAN or WAN using the rear panel RJ-45 LAN connector
(see figure 2 on page 8).
Open a web browser on a PC connected on the same LAN or WAN.
Enter the FOX3 Matrix IP address in the browser Address field.
NOTE: If the local system administrators have not changed the value, the factory-
specified default is 192.168.254.254.
Press the <Enter> key on the keyboard.
The FOX3 is password protected. Enter a user name (user or admin) in the Username
field and the password in the Password field when prompted (see
page 41).
NOTE: The factory configured passwords for all accounts on this device have
been set to the device serial number. In the event of a complete system reset, the
passwords convert to the default, which is extron for the Admin and User (see
Roles and Permissions Panel
Internet Explorer . This chapter describes the factory-
® ®
on page 45 to change a password).
FOX3 Matrix Series Switcher • Internal Web Page
figure 27 on
40