Extron electronics FOX3 Matrix Series User Manual page 58

NOTES:
• The I/O boards are hot-swappable. You do not need to power down the switcher to
remove or install an I/O board.
• The diagram shows the 40x frame, which is similar in function to all matrix frames.
Remove and replace an I/O module as follows:
1. Disconnect any connected cables.
2. Rotate the left and right captive panel screws to completely loosen the screws (see
figure 38).
Figure 38. I/O Board Replacement
3. Gently pull on the captive panel screws to loosen the module from the backplane.
4. Slide the module out of the chassis.
5. Place the removed module on an anti-static surface or in an anti-static container.
6. Align the replacement module with the left and right chassis guides.
7. Gently slide the replacement module into the enclosure. Slide the replacement module
toward the front panel until it meets resistance.
8. Gently seat the replacement module into the backplane.
9. Use a screwdriver to tighten the left and right captive panel screws to lock the
replacement module in place.
FOX3 Matrix Series Switcher • Maintenance and Modifications
D IO
A U N
R IX IO
N S
M AT PA
X 3 E X
FO N TE
D A IO N
NS
PA
DI O EX AT
AU
D M P N
N S IO
TS R
O UT PU PA
L E X
DI O
AU R
L 3
S R 4 R
TS
IN PU 1 L
DI O L
2 R
AU R
L 3 L
4
R
1 L
2 R
L
N
LA
O TE
R EM
LY 2
ro n M B -23
E xt S E RS
A S
N
FA G
Rx
Tx
D Align with Plastic Guides
G EN
U T LE 0
33 -4
O U TP 2
25 -3
U T/ 4
IN P 17 -2
9- 16 ET
8 R ES
1-
Captive Panel Screw
50