Maintenance; Removing The Protective Cover - 3D Histech Pannoramic DESK II User Manual

Pannoramic DESK II 1.22 User's Guide

5.3 Maintenance

This section describes the most common maintenance solutions that can be performed by the user of
the product. For maintenance solutions not described in this manual, contact the service personnel.

5.3.1 Removing the protective cover

To replace the halogen lamp, (or to perform other maintenance work) and to interrupt a running
digitization procedure because of slide jamming, the protective cover of the Pannoramic DESK II need
to be removed in order to eliminate the problem.
Before removing the cover, exit the control software, switch off the 24 V power supply and
disconnect the power
Only instructed persons or service technicians can open the device
completely!
June 24, 2016 - Rev. 1
cables.
Caution!
Figure 46 – Removing/reattaching the cover
3DHISTECH Ltd.
5 Troubleshooting and Maintenance
68(76)