3D Histech Pannoramic DESK II User Manual page 70

Pannoramic DESK II 1.22 User's Guide
1. Exit control software.
2. Switch off power supply and disconnect power cable.
3. Remove the cover (see section 5.3.1 Removing the protective cover ).
4. Throw fixing lever (3) frontward to the left.
5. Remove the slide (1) from the holder (2).
If the slide is broken, make sure to remove all pieces completely from
the device. The edge of the broken area of the slide is sharp and it can lead
to injury and contagion! Broken slide can be removed only by a well-trained
person!
6. Swing fixing lever (3) back to the right towards the holder.
7. Reattach the cover (see section 5.3.1 Removing the protective cover ).
8. Connect the power cable of the power supply to the power outlet and switch on the power
supply.
9. Launch control software.
June 24, 2016 - Rev. 1
Figure 47 – Removing a slide
Warning!
3DHISTECH Ltd.
5 Troubleshooting and Maintenance
70(76)