Composite Connector - Furuno TZT19F Installation Manual

Multi function
Hide thumbs Also See for TZT19F:
Table of Contents

Advertisement

2. WIRING
2.2

Composite Connector

The composite connector, at the rear of the unit (See the figure on page 2-1), contains
connection leads for Video In (two leads), LAN (two leads), HDMI (two leads for
input and output), NMEA2000, MULTI, USB port and DI-FFAMP.
Analog video input
The TZT19F can use regular analog video inputs (PAL or NTSC) that
connect to the TZT19F directly via the Video Input 1/2 connectors. Analog video can
be viewed only on the equipment where the source is connected.
Additionally FLIR cameras may be connected to the TZT19F. Connect the Video Out
cable from the camera to the Video In (1 or 2) cable on the TZT19F.
Note: Some camera models may require an adapter for connection.
Cameras may be set up using the appropriate menu item on the [Camera] menu,
accessed from the [Settings] menu. For details on camera setup, see the operator's
manual (OME-45120-x).
Nerwork1/2
You can connect to an external network device using a LAN cable. Use HUB-101 (op-
tion) when connecting multiple devices. The MCU-005 can be also used by using a
PoE hub.
Video out (external HDMI monitor)
A HDMI monitor can be connected to the TZT19F to repeat the screen at a remote
location. The TZT19F is compatible with wide-screen HDMI monitors which meet the
following minimum requirements:
Resolution
1920
Video in (HDMI Source Devices)
Video data from HDMI source devices can be watched on TZT19F by connecting the
device.
CAN bus port
TZT19F can be connected to multiple NavNet TZtouch3 using the CAN bus connector
(micro type). In that case, connect them all to the same CAN bus backbone cable. See
section 2.8 for details.
MULTI port
You can connect to external devices such as buzzers and event switches. See
section 2.5 for details.
USB port
The TZT19F has two USB Ver. 2.0 ports which can be used to connect an optional SD
card unit or remote control unit, and to be operated from touch device or PC mouse.
2-2
Vert. Frequency
1080
60 Hz
Horiz. Frequency
Pixel clock
67.5 kHz
148.5 MHz

Advertisement

Table of Contents
loading

Table of Contents