Table of Contents
Advertisement
3. HOW TO SET UP THE EQUIPMENT
Menu item
[Total Fuel Capacity]
[Manual Fuel Manage-
ment]
[Initial Setup] menu - [YAMAHA ENGINE SETUP]
Menu item
[Trip & Mainte-
nance]
[Trim Level Calibra-
tion]
[Fuel Flow Calibra-
tion]
[Engine Interface
Software Ver. & ID]
[Reset Engine Inter-
face]
[Reset Engine In-
stance]
[Reset Number of
Engines]
[Trouble Codes]
[Initial Setup] menu - [IF-NMEAFI SETUP]
Menu item
[Select IF]
[Category]
[Resistance Full]
[Resistance Mid]
[Resistance Empty]
[Capacity]
[Self test]
[Set Hardware to
Factory Default]
3-6
Manual Fuel Management Setup
Description
Enter the total fuel capacity of your
tank(s).
Set to [ON] for manual fuel manage-
ment. See the Operator's Manual.
Description
Reset fuel used, trip distance, engine trip and
maintenance hours (trip hour, standard hour,
optional hour, total hour).
Trim all engines to fully down position (zero).
If trim level is not zero, tap [SET] to set trim
level to zero.
If the fuel flow indication (gph=gallons per
hour) is wrong, you can calibrate the indica-
tion to show correct flow. Enter a negative val-
ue if the indication is higher than actual; a
positive value if the indication is lower than ac-
tual.
Display engine interface software version and
ID.
Reset engine interface.
Reset engine instance.
Enter number of engines.
Display trouble codes. For Yamaha engine
trouble codes, see the manual for the Yamaha
engine.
Description
Select [IF-NMEAFI] to set the analog data that is input from the IF-NMEAFI.
The setting is made after restarting the IF-NMEAFI.
Select the use (category) for this sensor.
The resistance, in Ohms, when the tank is full. 0 (ohm) to 500 (Ohm)
The resistance, in Ohms, when the tank is half
full.
The resistance, in Ohms, when the tank is
empty.
The capacity of the tank.
Test results are displayed.
Resets the converter selected at
[Select IF] to factory default.
Options (setting range)
0 to 9,999(L).
[OFF], [ON].
Options (setting range)
[Trip Fuel & Distance]: [Fuel
Used], [Trip Distance].
[Trip & Maintenance Hours]:
[Port], [Starboard].
–
-7 to +7
–
–
–
[1], [2], [3], [4], [4P], [4S]
–
Options (setting range)
[Wind], [ST800_850], [Fuel],
[FreshWater], [WasteWater],
[LiveWell], [Oil], [BlackWater]
0 (ohm) to 500 (Ohm)
0 (ohm) to 500 (Ohm)
0 (G) to 2650 (G)
[OK], [Cancel]
Advertisement
Table of Contents
