Table of Contents
Advertisement
Menu item
[High Frequency (KHz)]
[Transducer Power HF]
[Band Width (HF)]
[Low Frequency (KHz)]
[Transducer Power LF]
[Band Width (LF)]
Motion sensor menu
Adjust these settings to view a clearer picture of the seabed, fish schools etc when in
moderate-to-rough seas.
Note 1: For connection of NMEA 0183 equipment, ask your dealer to set up the equip-
ment.
Note 2: To use the heaving function, the following settings are required at the satellite
compass. For the setting procedure, see the operator's manual for your satellite com-
pass. Settings for SC-30 are done from the [IF-NMEASC] menu, settings for SC-50/
110 are done from the [DATA OUT] menu.
Sentence
Baud rate
Cycle
PGN
The [MOTION SENSOR] menu appears in the [Transducer Setup] menu when the
[Heaving Correction] is activated in the [Fish Finder] menu. If the satellite compass
SC-30 or SC50/110 is connected, set the distance between the antenna unit (or sen-
sor) of the satellite compass and transducer (high and low if connected) here.
When [Transducer Setup Type] is set to [Manual]
Set the kHz frequency for high frequency. Setting ranges vary
depending on the transducer connected.
Set the transmission power for high frequency.
Note 1: This menu item is available only for
DFF1, DFF1-UHD, BBDS1 and internal fish
finder users.
Note 2: For DFF1-UHD users, when the con-
nected transducer TDID is not supported by the
DFF1-UHD, the setting is fixed as [1000].
Set the bandwidth for high frequency.
Note: This item is only available for DFF3 users
when the Transducer type is set to [Manual].
Set the kHz frequency for low frequency. Setting ranges vary
depending on the transducer connected.
Set the transmission power for low frequency.
Note 1: This menu item is available only for
DFF1, DFF1-UHD, BBDS1 and internal fish
finder users.
Note 2: For DFF1-UHD users, when the con-
nected transducer TDID is not supported by the
DFF1-UHD, the setting is fixed as [1000].
Set the bandwidth for low frequency.
Note: This item is only available for DFF3
users.
ATT, HVE
38400BPS
25ms
3. HOW TO SET UP THE EQUIPMENT
Description
NMEA0183
Heave: 65280
Attitude: 127257
Options
(setting range)
[600], [1000]
[10] to [100]
[600], [1000]
[10] to [100]
CANbus
3-17
Advertisement
Table of Contents
