Table of Contents
Advertisement
2.3.3 Input/Output Card Options
With both display and virtu SDI cards installed, it is thus possible to achieve different
combinations of views on the monitors. Refer to the
information.
2.4
Removable Hard Disk Installation
This section shows you how the 2.5" HDD in Removable Rack can be assembled.
Warning: You must use the TVS-1200A proprietary HDD and not any Datavideo HDR series or
DN series.
Avoid HOT PLUGGING during operation (while writing to and reading from the disk) because
it may cause damage to the system and files.
Configuration – Layout
Display Card
Display card allows connection of two DVI-
D ports, one HDMI output port or one
DisplayPort.
Note: It is recommended to connect
production window (Monitor 1) to HDMI
port.
Virtu SDI Card
Virtu SDI card allows connection of two SDI
input/output pair, a mini phone jack for
audio input and a tally output.
1. Remove the two screws on the rear cover
of the removable 2.5" HDD enclosure and
manually pull out the PCB.
2. Place a 2.5" SATA HDD on the PCB and then
turn it over so you can secure the drive to the
PCB by screwing the four screws (supplied)
into the holes as shown in the diagram on the
left.
11
section for more
Advertisement
Table of Contents
