Table of Contents
Advertisement
Buttons in the lower part of the Media Bin are used to control the file played in the player. The
available functions are: Play
The playback progress bar, information on the video length and the current playback position
are also shown. Right after being double clicked in the bin, a video is loaded into a virtual
player and begins to be played in a loop. If the loop playback is switched off, the video will
stop on the last frame. Pressing the Stop button causes playback to return to the first frame.
The Media Bin also has mark-in and mark-out features that allow the user to set a start point
and an end point before playback of a video clip. The user can simply move the cursor on the
playback progress bar and fine tune the cursor position frame by frame by clicking the forward
and reverse
In addition, by checking the PlayAll option and enabling the loop feature, the user is allowing
loop playback of the whole media folder. AutoPlay allows the virtual player to play the video
clip upon entering the media folder.
NOTE: It is recommended that files should be added to the Media Bin only from a hard disk
permanently connected to the workstation. If files from other media need to be used, they
should be physically copied to the hard disk and only then added to the Media Bin.
Media 1/2 – As depicted in the diagram below, this is where the video files can be displayed.
Click on
to browse the local hard disk for video files. The user is allowed to classify the
selected video files into five categories. Navigate through the categories by clicking on buttons
1 to 5 located on the right of the file display area.
The formats and codecs supported for video files (for media added to the MEDIA1 and
MEDIA2 tabs) are:
-
H.264/AVCH.264/AVC Smart Render Wrapper
-
H.265/HEVC
-
MPEG-1/2
-
MPEG-2 Smart Render Wrapper
MPEG-4 P.2 / H.263
-
, Pause
, Stop
buttons.
45
, and Loop
(Loop is on by default).
Advertisement
Table of Contents
