Table of Contents
Advertisement
2.3.3 Input/Output Card Options
With both display and virtu SDI cards installed, it is thus possible to achieve different
combinations of views on the monitors. For more information, please refer to
Layout
section.
2.4
Removable Hard Disk Installation
How to Assemble 2.5" HDD in Removable Rack
Warning: You must use the TVS-1000A proprietary HDD and not any Datavideo HDR series or
DN series.
Avoid HOT PLUGGING during operation (while writing to and reading from the disk) because it
may cause damage to the system and files.
Display Card (One of the following)
Display card allows connection of two DVI-D
ports, one HDMI output port or one
DisplayPort.
Note: It is recommended to connect
production window (Monitor 1) to HDMI
port.
Display card allows connection of one DVI-I
ports, one HDMI output port or three
DisplayPorts.
Virtu Card
Virtu card allows connection of a single
HDMI input/output pair and a mini phone
jack for audio input.
1. Remove the two screws on the rear cover of
the removable 2.5" HDD enclosure and manually
pull out the PCB.
2. Place a 2.5" SATA HDD on the PCB and then
turn it over so you can secure the drive to the PCB
by screwing the four screws (supplied) into the
holes as shown in the diagram on the left.
10
Configuration –
(MSI GTX 960)
Advertisement
Table of Contents
