General Display And Audio Settings - Datavideo TVS-1200A Instruction Manual

In the example above, three monitors are connected and the user is thus able to shuffle
monitor assignments by making selection of the desired display in the pull-down menu below
each monitor window.
5.7

General Display and Audio Settings

To configure additional display settings, click on the General tab where the user will find two
options, Image default playback time (sec) and Mirror on PGM Monitor as shown in the
diagram below. By checking the option, Image default playback time (sec), the user will then
be allowed to set the playback time for slide show of still images. Mirror on PGM Monitor,
after enabled, will display a mirrored image of the Program View, i.e., the Program view image
is flipped along the y-axis.
In addition, the TVS-1200A is able to output PGM audio on the selected sound card. To hear
the PGM audio, follow the steps outlined below to configure your system setup.
1. Connect any sound playing device to the motherboard's audio output jack.
2. Open the "Configuration" window and select the "General" tab.
3. On the "Configuration" window, locate the Motherboard Audio Output section and select
a sound card from the "OUTPUT" pulldown menu. The TVS system, by default, selects the
Windows sound card. In the example above, we have selected the Realtek High Definition
Audio.
4. Click OK.
5. The PGM embedded audio should now be heard on the sound card's audio output. The
user is allowed to mute or adjust the volume on the motherboard's Audio Manager
Interface.
6. The selection will be remembered once the Motherboard Audio Output has been
configured. In this way, after the audio cable is disconnected from the TVS system, the
connection will be automatically re-established after the audio cable is plugged back in
again.
48