Piston Screw Lubrication - 3D Systems ZPrinter 350 User Manual

® ®
ZPrinter 350 / ZPrinter
3. Slide the Carriage back and forth to distribute the grease evenly over the Top Rail.
4. Clean the excess grease off the Top Rail and Carriage.
5. Reset the Maintenance Counter in ZPrint.

6.3 Piston Screw Lubrication

Frequency: When prompted to in ZPrint.
1. Remove both the upper and lower rear cover panels of the printer.
2. Remove the left (Build Chamber) side panel.
3. On the LCD display, select
and lower the Build Bed platform as far as you can to expose the entire length of the piston screw.
4. Assemble the grease gun that is part of your Accessories Kit according to the instructions found in the
document 09576 Grease Gun Loading Instructions, which is supplied in the materials that were
shipped with the printer. You can also find these instructions on our Web site at
3dscentral.3dsystems.com.
5. Look into the left end of the printer, and locate the piston screw.
3dscentral.3dsystems.com
10/31/12
450 User Manual
Number Component
1 Fast Axis Grease Fitting
2 Relief Hole
BUILD CHAMBER > LOWER PLATFORM.
52
Printer Maintenance
Hold the Control Knob down
All Rights Reserved