Empty The Debris Separator - 3D Systems ZPrinter 350 User Manual

® ®
ZPrinter 350 / ZPrinter
you continue to vacuum powder into the feeder, the LCD will display
and the vacuum will be disabled.
7. When you are finished, return the hose to its holder.
Important: Never vacuum up water or other fluids - it will clog the vacuum system.

3.2 Empty The Debris Separator

After vacuuming, empty the Debris Separator. The Debris Separator catches any large particles and keeps
those pieces from being recycled into the feeder. To empty the Debris Separator follow the steps below.
1. Pull the Debris Separator out of its holder on the printer.
2. Empty the contents into a trash receptacle.
3. Use the soft brush found in the Accessory Kit to brush any caked-on powder from the screen.
4. Return the empty Debris Separator to its holder. Be sure to push the Separator flat against the panel
for a secure fit.
3dscentral.3dsystems.com
10/31/12
450 User Manual
31
Routine Cleaning
FEEDER POWDER LIMIT
All Rights Reserved