Dry The Part - 3D Systems ZPrinter 350 User Manual

® ®
ZPrinter 350 / ZPrinter 450 User Manual Setup And Print The Build

2.9 Dry The Part

When your part is finished printing, the printer runs a drying cycle. A timer on the LCD menu will count
down the time remaining to dry the part. Drying the part gives it added strength, so you should not handle
parts before they have adequately dried.
You can leave the part in the Build Bed after the drying cycle ends and it will continue to increase in
strength. The longer a part is dried the stronger it becomes, although until it is infiltrated, it will still be frag-
ile and should be handled with care.
3dscentral.3dsystems.com 26 All Rights Reserved
10/31/12