Clean The Fast Axis Rails And Carriage - 3D Systems ZPrinter 350 User Manual

® ®
ZPrinter 350 / ZPrinter

3.3 Clean The Fast Axis Rails and Carriage

Keeping the Fast Axis Rails and Carriage clean will keep the Carriage moving smoothly and thus optimize
printing accuracy.
1. Open the printer top cover and pull the fast axis forward until it stops.
2. Lay clean paper towels under the Fast Axis.
3. Using a paper towel dampened with distilled water, wipe the top and bottom Rails to remove any pow-
der. Move the Carriage back and forth as needed to clean the entire length of both rails.
4. Dry both Rails thoroughly with a clean dry paper towel.
5. Using a fresh paper towel, wipe the Carriage to remove any powder.
6. Wipe or vacuum the Build Bed and Deck as needed to remove any powder dislodged from the Rails
and Carriage.
Important: Never vacuum up water or other fluids - it will clog the vacuum system.
3dscentral.3dsystems.com
10/31/12
450 User Manual
Number Component
1 Top Rail
2 Bottom Rail
32
Routine Cleaning
All Rights Reserved