Add Binder - 3D Systems ZPrinter 350 User Manual

® ®
ZPrinter 350 / ZPrinter

5.4 Add Binder

If there is not enough binder in the cartridge, ZPrint displays
Important: Do not add binder unless you are prompted to in the ZPrint Printer Status dialog.
To add binder, follow the steps below.
1. Pull the empty binder cartridge out of its housing on the printer.
2. Get a new binder cartridge. Check the expiration date, and check the cartridge label for the correct ori-
entation.
3. Insert the cartridge into its housing. Ensure the cartridge is pushed all the way in. You should feel it
gently snap into place.
Important: If a cartridge does not snap into place, do not force it. Check the orientation and that it is
the correct type and try again.
3dscentral.3dsystems.com
10/31/12
450 User Manual
BINDER LOW in the Printer Status dialog.
47
Additional Operations
All Rights Reserved