Replace The Waste Tray; Position Build Piston (Build Bed); Cover - 3D Systems ZPrinter 350 User Manual

® ®
ZPrinter 350 / ZPrinter 450 User Manual Additional Operations
4. Replace the cap and close the Service Station cover.
5. Reset the Maintenance Counter in ZPrint. See the ZPrint Software Manual for details on how to do
this.

5.7 Replace the Waste Tray

If the Waste Tray is Full, ZPrint displays EMPTY WASTE TRAY in the Printer Status dialog.
To replace the Waste Tray, follow the steps below.
1. Remove rear bottom cover.
2. Pull the full Waste Tray out of its compartment on the printer.
3. Insert a new Waste Tray into its compartment. Ensure the Tray is pushed all the way in.
4. Replace the rear bottom panel.

5.8 Position Build Piston (Build Bed)

The Build Bed platform must be in its proper position at the top of the Build Bed in order for the printer to fill
the bed and spread a layer of powder before starting a print job. If you see the message RAISE BUILD in
the Printer Status dialog, go to the printer and select PREP BUILD CHAMBER to raise the platform to
its proper position.

5.9 Cover

The printer cannot start a print job when the top cover is open. If the top cover is open, go to the printer and
close it. Do not open the cover while the machine is printing.
3dscentral.3dsystems.com 50 All Rights Reserved
10/31/12