Table of Contents
Advertisement
2. Position the fuel line primer bulb so the arrow on the side of the bulb is
pointing up. Squeeze the fuel line primer bulb several times until it feels
firm.
IMPORTANT: To prevent engine flooding, do not squeeze the primer bulb
after the engine has warmed up.
3. Set the lanyard stop switch to the RUN position. Refer to General
Information ‑ Lanyard Stop Switch.
4. Set the tiller handle gear shift to the neutral (N) position.
5. Cold engine ‑
• Pull the choke knob out two detent positions for starting a cold engine.
The choke is closed in this position.
• After the engine is running, push the choke knob in one detent. The
choke is partially open in this position.
OPERATION
27348
19791
68
57677
eng
Advertisement
Table of Contents
