Table of Contents
Advertisement
4. Unscrew the old filter by turning the filter to the left.
5. Clean the mounting base. Apply a film of clean oil to the filter gasket. Do
not use grease. Screw the new filter on until the gasket contacts the base,
then tighten 3/4 to 1 turn.
6. If the starter solenoid was removed, install the starter solenoid and rubber
isolation mount to the metal plate.
OIL FILLING
IMPORTANT: Do not try to fill the oil level to the top of the operating range
(upper hole). Oil level is correct as long as it appears in the operating range
between the upper and lower hole.
1. Position the outboard in a level operating position.
2. Remove the oil fill cap and add the recommended oil to the midpoint
(middle hole) of the oil level operating range. Adding approximately
1.0 liter (1.1 U.S. quart) of oil will bring the oil level to the midpoint of the
oil level range. Reinstall the oil fill cap.
b
a
a -
Oil level operating range
b -
Midpoint
c -
Dipstick
d -
Oil fill cap
MAINTENANCE
c
94
31993
d
31997
eng
Advertisement
Table of Contents
