Steering Bracket, Steering Cable Installation - Mercury 25 Jet 4-Stroke Manual

The outboard must be secured to the transom with the two transom
bracket clamp screws and four 13 mm (1/2 in.) diameter mounting
bolts and locknuts provided. Install two bolts through the upper set
of mounting holes and two bolts through the lower set of mounting
slots.
a - Bolt
b - Transom clamp bolt

Steering Bracket, Steering Cable Installation

1. Lubricate entire cable end with 2‑4‑C with Teflon.
Tube Ref No.
2-4-C with Teflon
95
2. Install the cable seal onto the tilt tube.
3. Install the steering bracket with two washers and two
30 x 80 mm bolts. Tighten the steering bracket bolts to the
specified torque.
ENGINE INSTALLATION
a
Description
b
c
d
10175
c - Washer
d - Nut
Where Used
Steering cable end
104
10261
Part No.
92-802859A1